Vibration Pulverizer with Sand and Gravel

Everyone knows that choosing a product or service, to understand from all aspects of the milling machine, service, quality, etc.

The main application of Vibration Pulverizer with Sand and Gravel determines its extensive application range and finished product.
Typical materials are: super hard diamond, silicon carbide, metal powder, etc. High purity requirements: ceramic color, medicine, biochemistry, etc., low temperature requirements: medicine, PVC. By changing the normal air of the gas source into an inert gas such as nitrogen and carbon dioxide gas, it can be used as an inert gas protection device. Suitable for crushing of flammable and explosive and oxidative materials.

ALPA Sodium Sands Vibration Pulverizer with Sand and Gravel Case Sharing: This customer is mainly engaged in high energy chemistry, hydrogen production and hydrogen energy development, special gas, fine chemical, environmental engineering, etc. The research institute requires a device that can be superfined with sodium chlorate. Find a domestic powder equipment enterprise. Finally, I bought a Vibration Pulverizer with Sand and Gravel in our AlPa.

Technical parameters:
Finished granularity: 100-325 目
Production capacity: 500kg

The operation process of Vibration Pulverizer with Sand and Gravel is very important, you need to pay attention to the following Point:

1, check all the lines, electrical components, etc. of the pulverizer, whether it can work properly. Whether the machine is grounded, so that the housing is powered by electric shock. Whether the machine spindle has a card death, if it should be handled in time. Whether the machine has an abnormal situation during operation, if there is a stop check.

2, check the blade, is tightened, whether the blade gap can reach the specified standard. Before using the pulverizer, check the working room is enough or slidable, if it should be removed in time.
3, after the offset is running, it can begin to start the feed. The pulverizer should stop the feed before stopping. Wait until the machine is completely discharged, it can be stopped.
4, the feed should be uniform, not over, so as not to increase the burden on the machine. The pulverizer cannot be cleaned, maintenance, etc. during operation.


For more consultation, please continue to pay attention to us, or inquire.