Turbo Mills of Azodicarbonamide

With the development of society, the application of Turbo Mills of Azodicarbonamide has become more and more.

The following is a detailed description:

1. Feeding granularity control

Most Turbo Mills of Azodicarbonamide has a certain upper limit requirement for the particle size of the feed. After entering the pulverization cavity, it can be sufficiently accelerated before collision and crushing with other particles. It is difficult to completely accelerate after large particles enter the pulverized cavity, which will allow them to stay in the machine too long, resulting in too high energy consumption. Therefore, in large-scale production of ultrafine powder, it is an effective way to pre-ground the raw material of the particle size is an effective pathway for energy saving.
2. Working medium

Currently, the working medium of Turbo Mills of Azodicarbonamide is mainly compressed, superheated steam, inert gas, and the like. The choice of working fluid has a certain impact on crushing effects and economics. Superheated steam is superior to air in fluidity and critical flow rates to achieve higher flow rates and uniform flow fields. However, using superheated steam as a working fluid, it must be ensured that it is still in an overheating state before entering the product capture device, otherwise the material is condensed.
3. Feeding speed

Feeding speed is an important parameter reflecting gas flow grinding production capacity. During the pulverization process, the optimum ratio of the intake flow rate and the feed speed is the key to improving the crushing efficiency. In general, under certain intake flow conditions, the feed speed is proportional to the particle size of the product. However, the feeding speed is too fast, which will increase the particle density, mutual interference, disadvantage of the particles, and difficult to achieve the sufficient and effective collision between particles, affect the crushing effect; although the feed speed is too slow, the particles stay in the crush area The time can be extended, which will reduce the particle density, reduce the collision rate, resulting in a decrease in production capacity and an increase in unit production energy consumption.
4. Granular limit

Turbo Mills of Azodicarbonamide In the pulverization process, as the material particle size is reduced, the crystallization and intensity of the material increases. After reaching a certain degree, the particle size of the material is no longer reduced or reduced, that is, the crushing limit of the material is reached. At this time, the material specific surface area increases, the surface activity of the particles, the particle agglomeration and grinding are in a dynamic equilibrium state, even if the grinding time is prolonged, it is difficult to further reduce the particle size of the material.


AlPa modified quartz, silicon fine powder Turbo MillsOf azodicarbonamide case share:
A material company is a high-tech enterprise integrating research and development, production, sales and technical services in a series of products such as inorganic non-metallic powder materials and surface treatment.
The company has a series of automated production equipment and testing instruments such as fine grinding, precision grading, and surface cover to compound mixing; high purification, ultrafine, sphericalization, and Its surface coating treatment is deeply processed, whether it is a formulation optimization or a custom research and development of new products.
Case parameters

Hour yield: 3-10kg

Turbo Mills of Azodicarbonamide is a crusher, any mechanical equipment, before use There must be a certain precaution, be sure to check the precautions, so that the damage rate is minimized, then what is the precaution before using a jet ball mill? Here are some introductions.
1. Check whether the firmware is tight before use, whether the spindle direction is correct, so as not to damage the machine.
2, the pulverizer should be lubricated in accordance with the requirements so that the machine is operating normally.
3, the material cannot be mixed before the grinding machine is added to avoid damaging the pulverizer.

5. When using the crusher, if there is abnormality, it should be handled immediately to avoid a large loss.
6. If damage should be replaced immediately, certain components should be checked regularly.
ALPA Technology recommends that you must pay attention to the performance of the equipment during the use of ultrafine airflow classifiers, jet grading machines, powder classifiers, must pay attention to regular inspection equipment performance and prevent malfunctions during use.