Turbo Grinder for Wheat

With the continuous increase in social needs, Turbo Grinder for Wheat continues to improve in the use of performance, finished product quality, service life, etc., very well, which is well processed into microtes and even nanoscale fine powder, and it is already chemical. Food, pesticides, cosmetics, dyes, coatings, electrons, etc. have been widely used.

A Turbo Grinder for Wheat cost is high, if you want to use Turbo Grinder for Wheat for a long time, please pay attention to the following:

1. In the production process, you should check The temperature rise of the bearing, when the temperature rise exceeds 50 ° C, the examination should be stopped, find out the cause, and troubleshoot.
2. When the new machine is running, the transmission belt is easy to eliminate, so it should be noted to adjust the appropriate tightness of the belt to ensure the life of the belt.
3. Test and timely replacement of vulnerable parts should be performed in time to ensure quality and production.
4. The wear of the blade and bushing should be continuously checked. If the productivity is lowered, the particle size is thick after wear, and the wear is immediately replaced.
5.Turbo Grinder for Wheat's host and level distribution bearing uses special grease (265-295 degrees) lubrication.
6. The replacement period of the bearing is 2000 hours, and the amount of oil filling of the bearing chamber gap is 1 ≤ 2 (try) or 3 ≤ 4 (try), if it is not too much, the bearing temperature Will be too high.
7. The replacement period of the spiral feeder is 4,000 hours, and ordinary calcium based grease is added. Standard operation to exchange for longer use of airflow crushers.

The above is a seven point introduction to the daily maintenance of Turbo Grinder for Wheat.


ALPA Trimetic Material Turbo Grinder for WheT Case Sharing: The company requires a three-dimensional material ultrafine pulverizer, and our Alpa's Turbo Grinder for Wheat is also more well known in the industry. There is a lot of proportion in the industry. Through experiment, the company purchased a Turbo Grinder for Wheat of our company.
Technical parameters:
finished particle size: D50: 10μm
Production capacity: 5-10kg / h

Installation, operation and maintenance is three important factors using Turbo Grinder for Wheat. The wear and consumption of each operation has always been a key factor in each startup operation.In order to use the airflow pulverizer for a long time, please adjust the open mode.Boot is a standard, for the first time to contact and use this kind of equipment, it is always a very strange state. In fact, it is very simple, the best way is to familiarize yourself with the consumer content on the instructions or have no use value.Timely specification and familiar.After each startup, check the airflow pulverizer in time to develop good usage habits.In the future, we don't need to pay attention to and familiarize.

Shan Dong Alpa is committed to Turbo Grinder for Wheat, has a mature process process, has a high-energy technology research and development team, specializing in crusher research and development, survive by quality, welcome everyone to come to consult.