Hammer Mill for Silicon Carbide

Hammer Mill for Silicon Carbide is better, only need to be produced in a smooth ground, and low noise, which can avoid dust leakage during the pulverization process, which is favored by the powder industry.

In terms of airflow milling, it is important to understand its operational rules, which is very important because only familiarize the procedure, can operate correctly.
1. The operating rules of Hammer Mill for Silicon Carbide are as follows: Prepare materials before the start of the production order, prepare materials. Complete the site to clean the grocery. Check whether the transportation pipes and auxiliary equipment, whether the pipelines are blocked, leak or poor sealing, whether the auxiliary equipment is intact, whether it works normally. Whether there is a phenomenon that the material is accumulated in the outer casing and the separator, if the accumulated material is required. Whether the bearing is lubricated, whether it is lubricated in an appropriate place. Check if all pipes, fastening bolts, washers, spindles, and instruments are intact, normal and flexible.
Second, Hammer Mill for Silicon Carbide starts the motor, control the current and time at starting, so that the device can start running. When the equipment is operating normally, the feed speed can be adjusted according to the properties of the material. Uniform continuous feed should not be large or small, thereby affecting the separation effect of the grinding machine, making the machine easily malfunction. During operation, if an abnormality occurs, stop checking immediately before the failure continues.
Third, the main procedures of the closure and inspection of Hammer Mill for Silicon Carbide are as follows: After the material in the grinding machine housing is completely pulverized, it should stop the feed and turn off the motor. After the machine is idling for 3 minutes, press the stop button to stop the machine. When the machine is completely stopped, open the check door and check the wear of the vessel. Fill in the corresponding production record, update the device status flag, which is convenient for the next use.


ALPA Cassava Starch Hammer Mill for Silicon Carbide Case Sharing: This customer is a new type of panel company, dedicated to providing professional and excellent plywood new filler for plywood industry customers. The company needs to be used in the production process of the company. Multi-party examine, finally purchased the CSM1100-V mechanical grinder from our AlPa.
Technical parameters:
Finished product granularity: 98% over 325 mesh

Super-Hammer Mill for Silicon Carbide inspection work:
1 , Newly installed equipment, connect the equipment to be pulverizedIt is inevitable that foreign matter such as iron blocks, welding heads, welding slags will remain. In the absence of the fan and the main motor, open the implicit baffles under the feed port, allowing impurities and washing materials to be discharged from here. After the end, open the ultrafine pulverizer observation door, check whether there is impurities in the pulverizer, hammer head and ring gear have problems.
2, before checking everything is normal, the power-on starting the device, check the direction of rotation of all motors.

4, check whether the solenoid valve is blown normally, regulate the dust collector solenoid pulse width and blow interval.
5. Check if the cleaning of the cleaners under the brake dragon has a leakage, can be placed in the interface with the hand or fine powder, there is a feeling of suction, if there is a sealing treatment. After all of the above tests are normal, prepare the material production.

The above is the use of Hammer Mill for Silicon Carbide, you can pay more attention to us!