Pin Mills for Walnut

Pin Mills for Walnut is one of the common ultrafine pulverization methods, widely used in ultra-fine pulverization or fine pulverization of materials such as non-metallic mine, pharmaceutical, chemical, metallurgical and other industrial materials, has a fine particle size, narrow particle size distribution, particles The surface is smooth, the particle rules, high purity, and high activity.

PIN MILLS for Walnut is smashed in full-closed state, the fineness of the pulverized particles is better, the granular shape is good, the yield is also large, the pulverization process is no dust production, and the material is purified by the purity after crushing, greatly saves raw materials . Pin Mills for Walnut can reach the effect of cell-breaking wall during pulverization, so that the effective component dissolution of the medicinal material is greatly improved, and the efficacy is also more likely to be absorbed by the human body. Experts pointed out that after pulverizing the gas flow crusher, the minimal component can reach the original efficacy. During the pulverization process, it can work according to different medicinal materials and crushedness, generally use a gas flow pulverizer to pulverize the drug. It is possible to save resources between 30% and 70%.

ALPA potassium permanganate PIN MILLS for Walnut Sharing: The customer is mainly engaged in the development of high energy chemical energy development. The study needs a device that can make ultraf fine pulverized in high potassium permanganate. Finally, we bought a Pin Mills for Walnut in our AlPa.
Technical parameters:
Finished granularity:
100-325 目
Production capacity: 5kg

Let's talk about how to correctly use Pin Mills for Walnut [123 ]
1. Prepare before booting the host, attachment machine, pipeline, and valve, whether it is intact, whether it works fine.
Second, open

1. Turn on the compressor power supply, the pressure valve and the main valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power.
2. From the zero start grading wheel and gradually adjust to the specified speed.
3. Several turning wind turbines, cyclone separators discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break.
4. The particle size of the finished wheel can be adjusted by grading wheel frequencies and charging.
Third, the order of shutdown is: inverter - feeder - Main valve - Compressor - Stepper wheel Motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor.
4, repair

1. The motor should be lubed regularly, but the grease should not be too large, the bearing temperature is too high.
2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to checkCheck, belt and appropriate.
3. After a crushing material, after a certain period of time, it is necessary to remove the viscosity of the chalk, so as not to block, thereby affecting the crushing effect.
4. After the filter bag, you should clean or replace it.
V. Note

1. When the discharge device is running, the unloading port cannot be extended to avoid accidents.
2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric machine are damaged.
3. Regularly check the safety valve to ensure safety.

If the later period is intended for superfine grade machines, precision grading machines, jet classifiers, you can directly contact us, product quality is guaranteed, fair, good service, welcome everyone to buy!