Pin Mill for Chemically Derived Fiber

PIN MILL for Chemical Derived Fiber can be used for important or need to be grounded to particulate product processing, AlPA ultra-fine pulverizer product is good, affordable, factory direct sales, also push after-sales service service for customers, service attitude

PIN MILL for Chemically Derived Fiber is wide, simple and convenient, but during the pulverization process, often there is different cases of crushing effect.

The crushing effect is mainly affected by the following factors:

The temperature and pressure of the gas ratio, the feed particle size, the working fluid, and the pulverization aid. The gas-solid ratio of the pulverizer in crush is an important technical parameter and an important indicator. If the gas is too small, the kinetic energy of the airflow will be insufficient, which will affect the fineness of the product. But if the gas is too high, not only will waste energy, but will even degrade the dispersion performance of certain pigments.

When pulverizing hard materials, there is a stricter requirement for the particle size of the feed. In terms of titanium powder, it is necessary to control 100 to 200 mesh when pulverizing calcination; the material after pulverizing surface is generally 40 to 70 mesh, and cannot exceed 2 to 5 mesh.
So, should you choose how high pressure when crushing? Those skilled, this is mainly dependent on the comminutability and fineness requirements of the material.

A mechanical company is a research and development, manufacturing, manufacturing, solder wire equipment, tin powder equipment, solder paste equipment, pure zinc equipment, etc. High-tech enterprise.
With complete, scientific quality management system and powerful R \u0026 D team, and continuously improve product performance.
The company is also a large-scale professional equipment manufacturing enterprise in China.
Case parameters:
Product particle size: Remove 20UM with fine powder
hour production: Sakura efficiency 60-90%

1, often check the fastening of the components, preventing looseness from falling off, damaging the machine.
2, each oil injection hole should be refueling, and the bearing portion is cleaned every half year to fill the lithium-based grease.
3
4, when the machine is deactivated, the external debris should be cleared, and the grease is filled with all the rotating parts, stored in the storage of air drying, non-corrosive gas.