Turbo Mills of Ceria

With the development of the times, the progress of society, the development of the market is elegant, and more and more manufacturing have to accelerate innovation, some transformations, some continue to improve the technical level of the product, to adapt to the development of the market, Meet the customer's picky requirements. In the case of continuous changes in the market, only constantly innovation, continuously improve your technical level, and constantly improve your own products, in order to make the airflow classifier industry have a broader development space.

The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settle more in the air than in the water. Moreover, the density and viscosity of the air varies with temperature and pressure.
In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).

When the airflow is classified, the fine particles are typically taken away by the airflow. In some cases, the raw material is sent to the gas stream into a pulverized device.

It is well known that the load of solid particles in air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration of the solid in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.

The speed required to move the particulate material in the horizontal and vertical directions is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverization coal per centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.

In the rising airflow, the airflow speed required to suspend a certain density and particle size is greater than the calculated value of free settling, which is due to the uneven distribution of the airflow along the pulverizing chamber portion.

The Turbo Mills of Ceria has the characteristics of high pulverization, high pulverization efficiency, high pulverization accuracy, accurate cutting particle size, and good stability.
ALPA Pigment Turbo Mills of Ceria Case Sharing: This customer needs to use the pigment ultrafine pulverized equipment during its production. Improve the quality of the product through the ultrafine pulverization of the pigmentExcessive partial compared with type devices, finally chose our AlPa Turbo Mills of Ceria. Compared with the same type of equipment, our company's product reliability is higher, the pulverized particle size is more uniform, and the particle size after pulverization is narrow, and there will be no too much particle size range.
Technical parameters:
finished particle size: D90: 13μm;

Before using it, pay attention to it, you must pay attention to use, operation Make the damage rate can be minimized, then what should I pay attention to before using Turbo Mills of Ceria?
1, before use, check if all fasteners are fastened and whether the direction of operation of the spindle is correct, so as not to damage the machine.
2, lubrication should be performed as required to ensure the normal operation of the machine.

4, whether foreign matter or impurities, if it should be disposed in time to avoid damage to the tool.
5. If there is any abnormality in use, it should be treated immediately to avoid more loss.
6, some parts should be checked regularly. If it is damaged, it should be replaced immediately.

I hope everyone can buy the favorite of the airflow for the airflow!