Impact Mill Machine for Ferrite

Impact Mill Machine for Ferrite is good, only need to be produced in a smooth ground place, and low noise, which can avoid dust leakage during the pulverization process, favored by the powder industry.

The overall development trend of my country's material ultrafine crushing technology is to make a more ultra-fine pulverized equipment to various types of ultra-fine pulverization equipment towards low-cost, high efficiency, strong dispersibility, good dispersibility and stable quality. High technical requirements.
Impact Mill Machine for Ferrite Engineering Technology will need more and more high-purity ultrafine powder, ultrafine powder technology will play an increasingly important role in high-tech research and development. Although high-purity ultrafine powder is prepared by chemical synthesis, it is too high, which is extremely difficult for industrial production. The main means of obtaining the ultrafine powder is still mechanical and pulverized, and ultra-fine pulverization technology is a combination of many technologies. Its development also depends on the progress of the relevant technology.

Therefore, the main development trend of ultrafine pulverization equipment has been developed with fine pulverized equipment with ultrafine pulverized equipment. Ultrafine pulverized equipment with low energy consumption, small land, and has high handling capacity. Integrated development of equipment and process research.

Ultra-fine pulverization and supporting equipment must be adapted to specific bored features and product indicators, and the scale model must be adapted.

AlPa Cassava Starch Impact Mill Machine For Ferrite Case Sharing: This customer is a new panel industry, dedicated to providing professional and excellent plywood new fillers for plywood industry customers. The company needs to be used in the production process of the company. Multi-party examine, finally purchased the CSM1100-V mechanical grinder from our AlPa.

Technical parameters:
finished particle size: 98% over 325 mesh
Production capacity: 2T

Impact Mill Machine for Ferrite is widely used, do you know how to use it correctly? The following content hopes to help you.

1. Preparation before departure. Check if the host, connector, pipeline, and the valve are normal, working properly.
2, open the machine

(1) Open the compressor power supply, the dust collector pressure valve and the main air valve, open the air pulverizer power switch, and turn on the power switch.

(2) From zero, gradually adjust to the specified speed.

(3) Open the fan, cyclone separator, dust collector, charge motor, open the total power box, set the inverter frequency, and then start charging.
(4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel.

3, the order of the downtime:

inverter - feeder - Main air valve - Compressor - grade impeller - Motor cyclone material, dust removal switch - fan - Main power supply - air compressor.
4, Maintenance

(1) The motor should be lubricated regularly, but the lubricating oil should not excessively avoid the bearing temperature.
(2) Check the wear of impeller, helical conveyors, and crushing nozzles.
(3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect.
(4) After the filter bag, it should be cleaned or replaced.
5. Precautions

(1) When the discharge equipment is run, the unloading port cannot be reached, and the accident occurs.
(2) The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric chance are damaged.
(3) Regularly check the safety valve to ensure safety.

Through the above learning, it is more understanding for the maintenance of Impact Mill Machine for Ferrite.For more information, continue to pay attention to our website.