Rod Pin Mill for Reduced Iron Powder

Rod Pin Mill for Reduced Iron Powder is good, only need to be produced in a smooth floor placement, and low noise, which can avoid dust leakage during the pulverization process, which is favored by the powder industry.

Rod Pin Mill for Reduced Iron Powder temperature increases, when the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy.
When titanium powder is pulverized by superheated steam, the vapor pressure is usually 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after pulverized surface can be lower.
ALPA Soybean Rod Pin Mill for Reduced Iron Powder case share: This customer is a company in the Netherlands. The company needs ultrafine pulverization to soybean meal (after oily oil). Investigating European equipment manufacturers, integrating, or our ALPA equipment is better than the performance ratio, or from cost performance. Through the incoming experiment, the company chose our company's Rod Pin Mill for Reduced Iron Powder.

Any machine device must pay attention to it before use, you must pay attention to the use, operation, make it damaged to the lowest, then what should you pay attention to before using ROD PIN MILL for Reduced Iron Powder?

2, lubrication should be performed as required to ensure the normal operation of the machine.
3, before adding the material to the pulverizer, it is not mixed to avoid damage to the grinding machine.
4, whether foreign matter or impurities, if it should be disposed in time to avoid damage to the tool.
5. If there is any abnormality in use, it should be treated immediately to avoid more loss.
6, some parts should be checked regularly. If it is damaged, it should be replaced immediately.

Shandong AlPa is a 20-year experience manufacturing company with ROD PIN MILL For Reduced Iron Power devices, with a number of patents, welcome to callconsult!