Pin Mills for Zeolite

Pin Mills for Zeolite is well balanced, only need to be produced in a smooth floor, and low noise, which can avoid dust leakage during the pulverization process, favored by the powder industry.

PIN MILLS for Zeolite Transformed as a high-pressure air flow of pulverization kinetic energy into a crushing cavity, also is a gas flow distribution station, and the airflow passes through the Ravar nozzle accelerates supersonic airflow into the crushing chamber, the material Accelerated with the inquiral nozzle in the Wenqi.
Since the flow cycle of the jet of the crushing chamber and the animal feed, the particles and the particles and the fixed target wall hit, collide, friction, and grind. The fine particles were opened into the center of the pulverizer, and the cyclone separator was entered at the drive of the heart flow, and the coarse powder was thrown into the periphery of the pulverizing chamber, and cycled under the action of centrifugation and continued to be pulverized.

Technical parameters:
Production capacity: 2T +/- 10%

1. Before using, check all standard parts for the equipment before using Tighten, the belt is not tightening.
2, the spindle operation direction must conform to the direction of the arrow shown on the protective cover, otherwise it will damage the equipment, and may cause human damage.
3, check the electrical appliance is not intact.
4. Check the hardware such as metal-free materials in the equipment crushing room, otherwise it will damage the tool, affect the equipment operation.
5, the material must be checked before crushing, and there is no metal material hard article to be mixed to prevent crash or cause combustion.
6, the oil cup on the device should often be injected into the lubricant to ensure that the equipment is operating normally.
7. Stopping the feeding before the shutdown, if it does not continue to be used, clear the in the machine.
8. Check the tool with the screen on time is damaged. If it is damaged, it should be replaced first.
9. When using the timing, there is a small oscillation, so it is necessary to connect the handle to the handle to avoid accidents.

Welcome everyone to inquire!