Turbo Pulverizer of Soy Grains

In the classification operation of industrial production at this stage, the use of Turbo Pulverizer of Soy Grains mainly is targeted for the effective crushing of solid particles, and is a crushing device that is commonly used in the ultrafine comminution process.

A Turbo Pulverizer of Soy Grains cost is high, if you want to use Turbo Pulverizer of Soy Grains for a long time, please pay attention to the following:

In the production process, Temperature rises in the bearing frequently, when the temperature rise exceeds 50 ° C, the examination should be stopped, find out the cause, and troubleshoot.
2. When the new machine is running, the transmission belt is easy to eliminate, so it should be noted to adjust the appropriate tightness of the belt to ensure the life of the belt.
3. Test and timely replacement of vulnerable parts should be performed in time to ensure quality and production.
4. The wear of the blade and bushing should be continuously checked. If the productivity is lowered, the particle size is thick after wear, and the wear is immediately replaced.
5.Turbo Pulverizer of Soy Grains host and level score bearing use 2 special grease (265-295 degrees) lubrication.
6. The replacement period of the bearing is 2000 hours, and the amount of oil filling of the bearing chamber gap is 1 ≤ 2 (try) or 3 ≤ 4 (try), if it is not too much, the bearing temperature Will be too high.
7. The replacement period of the spiral feeder is 4,000 hours, and ordinary calcium based grease is added. Standard operation to exchange for longer use of airflow crushers.

The above is a seven-point introduction to the daily maintenance of Turbo Pulverizer of Soy Grains.



ALPA baked wheat Turbo Pulverizer of Soy Grains case share: This customer is a seasoning company, in the production process, it is necessary to use a wheat after baked wheat. Ultrafine pulverized equipment. Investigate a number of domestic enterprises in China, and finally chose our Alpa as partners, purchased Turbo Pulverizer of Soy Grains from us.
Technical parameters:
Finished granularity: D99.9: 180 mesh
Production capacity: 400kg

1, new Installed equipment, in the equipmentWhen it is connected to the crushing of the warehouse, it is inevitable that foreign matter such as iron blocks, welding bales, weld slags will remain. In the absence of the fan and the main motor, open the implicit baffles under the feed port, allowing impurities and washing materials to be discharged from here. After the end, open the ultrafine pulverizer observation door, check whether there is impurities in the pulverizer, hammer head and ring gear have problems.
2, before checking everything is normal, the power-on starting the device, check the direction of rotation of all motors.
3. Parameter inspection setting for the two inverters of the ultrafine pulverizer's feed motor and the graded wheel motor, check if the air open, contactor, heat relay, overcurrent relay adjustment is appropriate? Return all lines all over again.
4, check whether the solenoid valve is blown normally, regulate the dust collector solenoid pulse width and blow interval.

If you have something about other crushers, you want to know, welcome to consult!