Turbo Mill Machine of Asphalt GUM

We all know that Turbo Mill Machine of Asphalt gum is a strong airflow crushing equipment, many stubborn hard materials encountered a crusher, will be cut into a uniform block of pieces,

Turbo The working process of Mill Machine of Asphalt gum is mainly after the material is accelerated through the nozzle, and the compressed air enters the flow of the pulverization region, and the material is fluid, each particle has the same motion state. In the pulverized region, the accelerated particles collide with each other in each nozzle. The pulverized material is delivered to the grading area through the upper gas stream, and the fine powder of the particle size is selected by the horizontally arranged grading wheel, and the coarse powder that does not reach the granularity requirement, returns to the pulverization region to continue pulverization. Put the qualified fine powder with the airflow into the high-efficiency swirl separator, and purify the dust gas by the dust collector, discharged into the atmosphere, and the entire pulverization process reaches the high requirements of environmental protection.

AlPa Quartz powder Turbo Mill Machine of Asphalt gum case share:
Silicon fine powder company main products have molten stone sand, molten silicon fine powder, soft composite silicon fine powder, high purity ultra-fine silicon powder, activated silicon fine powder , Crystalline silicon fine powder, spherical silicon fine powder and other specifications are complete.
Main uses: Photovoltaic solar industry and electronic package materials, high temperature refractory materials, aerospace materials, quartz glass tubes, quartz ceramic rolls, and coated copper industries.
Case parameters:
Product particle size: Remove 20UM with fine powder
hour production: sorting efficiency 60-90%

Let's talk about how to properly use Turbo Mill Machine of Asphalt gum Method

1. Prepare before booting the host, attachment machine, pipeline, and valve, whether it is intact, whether it can work properly.
Second, open

1. Turn on the compressor power supply, the pressure valve and the main valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power.
2. From the zero start grading wheel and gradually adjust to the specified speed.
3. Several turning wind turbines, cyclone separators discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break.
4. The particle size of the finished wheel can be adjusted by grading wheel frequencies and charging.
Third, the order of shutdown is: inverter - feeder - Main valve - Compressor - Stepper wheel Motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor.
4, repair

1. The motor should be lubed regularly, but the grease should not be too large, the bearing temperature is too high.

2. Hierarchical impeller, screw feeder, crushing nozzle wear should pay attention to check, belt tight and suitable.
3. After a crushing material, after a certain period of time, it is necessary to remove the viscosity of the chalk, so as not to block, thereby affecting the crushing effect.
4. After the filter bag, you should clean or replace it.
V. Note

1. When the discharge device is running, the unloading port cannot be extended to avoid accidents.
2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric machine are damaged.
3. Regularly check the safety valve to ensure safety.
Shandong AlPa is a company with more than 20 years of gas generated enterprises. After years of gradual precipitation and accumulation, experienced, with multiple patented technologies.In the years, the airflow mill has been provided for domestic and foreign customers, there will be tens of thousands of equipment, often have a customer to order our products again, enough to explain the reputation of the Shandong AlPa airflow mill.Welcome to inquire!