Impact Mill Machine for Coconut Shell

Impact Mill Machine for Coconut Shell can be used for important or need to be grounded to granular product processing, AlPA ultrafine pulverizer products are good, affordable, factory direct sales, also push after-sales service service for customers, service attitude

Impact Mill Machine for Coconut Shell is also a factor affecting work efficiency. When the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy. When the titanium powder is pulverized by superheated steam, the vapor pressure is usually from 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after the pulverized surface is low.

Alpa Quartz Powder Impact Mill Machine for Coconut SHELL Case Sharing:
The main business scope of a silicon material includes: quartz, 坩 waste processing, production; silicon fine powder, square stone, molten stone, quartz sand, Kaolin, flame retardant sales; self-operated and proxy products and technology import and export business
Case parameters:
Product particle size: D97: 5-75UM
Hour Yield: 20-100kg

1, during production, the temperature rise of the bearing must be checked, and when the temperature rise exceeds 50 ° C, it should be downtown, and the reason is to rule out the fault.
2, when the new machine is running, the drive belt is easy to elongate, and should pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt.
3, if the loss case should be checked frequently, replace the quality and production volume in time.
4, the blade, the bushing should often check the wear situation. If the wear is worn, the productivity is lowered, and the particle size is replaced after the particle size is replaced.
5, the host and the graded flow bearing are lipids, and the No. 2 special lipids are used 265-295.
6, the replacement period of the bearing is 2000 hours, and the amount of the grease is filling the amount of the space in the bearing cavity (episode) or 3/4 (lower test) cut, not too much to fill the grease, otherwise The bearing temperature is too high.
7. The spiral feeder has been changed during the change of the lipid of 4,000 hours, and the calcium-based grease is added.

Shandong AlPa is an I20-year experience in the MPACT Mill Machine for Coconut Shell equipment, has a number of patents, welcome to inquire!