Rotor Mill Machine for Furazolidone

Currently, Rotor Mill Machine for Furazolidone has gradually entered people's lives, more and more plants, and companies are using the equipment.

Rotor Mill Machine for FURAZOLIDONE work is mainly, after the material is accelerated through the nozzle, the compressed air enters the flow of the pulverization region, and the material is fluid, each particle has the same motion state. . In the pulverized region, the accelerated particles collide with each other in each nozzle. The pulverized material is delivered to the grading area through the upper gas stream, and the fine powder of the particle size is selected by the horizontally arranged grading wheel, and the coarse powder that does not reach the granularity requirement, returns to the pulverization region to continue pulverization. Put the qualified fine powder with the airflow into the high-efficiency swirl separator, and purify the dust gas by the dust collector, discharged into the atmosphere, and the entire pulverization process reaches the high requirements of environmental protection.

AlPa Organic Pigment Rotor Mill Machine for Furazolidone case Share: The company is a Taiwan chemical raw material enterprise, and the company purchased a mechanical grinder for pulverizing organic pigments from our AlPa.
Technical parameters:
finished product particle size: D50 less than 325 mesh
Production capacity: 300kg

Ultrafa Rotor Mill Machine for FURAZOLIDONE correct usage:
1, super The microfiner and power unit should be installed firmly. If the ultrafine pulverizer is fixed, it should be fixed on the cement; if the pulverizer is a mobile operation, the unit should be installed on the base made of angle iron, and ensure the power machine (diesel or electric motor) and the pulverizer The belt wheel groove is in the same turning plane.
2, after the pulverizer is installed, check the fastening of the fasteners of each part, if there is loose to tighten. At the same time, check if the leather belt looseness is appropriate.
3 Whether the power machine and the pulverizing machine are lubricated.
4, do not casually replace the pulley to prevent the transition chamber to produce explosion, or the speed is too low to affect the work efficiency of the pulverizer.
5
6. At any time, you should pay attention to the operation of the pulverizer, and the feed should be evenly charged to prevent blocking, do not have a long time overload. If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.

To learn more about the knowledge of Rotor Mill Machine For Furazolidone, you will go to Shan Dong Alpa, the company is in the development and production of crusher and crusher related products, quality, and is well received by consumers.trustworthy.