Ring Roller Pulverizer for Carboxymethyl Cellulose

Ring Roller Pulverizer for Carboxymethyl Cellulose is a very convenient device that can be used to crush all kinds of products, especially some fine particle products need to be used.

Ring Roller Pulverizer for Carboxymethyl Cellulose Mainly used for processing more fine materials. The pulverized particle diameter is 1.5 to 0.005 mm, and the crude material is sieved.
The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settle more in the air than in the water. Moreover, the density and viscosity of the air varies with temperature and pressure.
In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).

When the airflow is classified, the fine particles are typically taken away by the airflow. In some cases, the raw material is sent to the gas stream into a pulverized device.

It is well known that the load of solid particles in air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration of the solid in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.

The speed required to move the particulate material in the horizontal and vertical directions is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverization coal per centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.

In the rising airflow, the airflow speed required to suspend a certain density and particle size is greater than the calculated value of free settling, which is due to the uneven distribution of the airflow along the pulverizing chamber portion.

The RING ROLLER PULRIZER for Carboxymethyl Cellulose has the characteristics of high pulverization, high pulverization efficiency, high pulverization accuracy, accurate cutting particle size, and good stability.
AlPA lysled carbon black Ring Roller Pulverizer for Carboxymethyl Cellulose case Share:The company is a renewable energy application company in Inner Mongolia. When the company recovers the waste tire, the ultrafine pulverized equipment needs to be ultrafielded by ultrafine pulverula. After many incidents, our AlPa Ring Roller Pulverizer for Carboxymethyl Cellizer for Carboxymethyl Cellulose was selected.
Technical parameters:

Production capacity: 2T


A must pay attention to it before use, you must pay attention to use, operation, The damage rate can be minimized, then what should I pay attention to before using Ring Roller Pulverizer for Carboxymethyl Cellulose?
1, before use, check if all fasteners are fastened and whether the direction of operation of the spindle is correct, so as not to damage the machine.

3, before adding the material to the pulverizer, it is not mixed to avoid damage to the grinding machine.
4, whether foreign matter or impurities, if it should be disposed in time to avoid damage to the tool.
5. If there is any abnormality in use, it should be treated immediately to avoid more loss.
6, some parts should be checked regularly. If it is damaged, it should be replaced immediately.
Welcome everyone to inquire!